Daaaaamn that looks beasty! (Very curious to see that spin!)
Anonymous — March 11, 2024 at 8:34 PM
Titanium screws? Pushing it to the limit :D
Ben Katz — March 11, 2024 at 10:22 PM
no, just blue zinc plated steel
Anonymous — March 12, 2024 at 5:02 AM
Ah i see (the shadow tricked me ;) it looks so good!
Anonymous — March 15, 2024 at 12:57 PM
Do you ever experience high spots from post-machining OTS gears? KHK warns against this for warping reasons, I was curious for your experience!
Ben Katz — March 15, 2024 at 2:37 PM
I saw that a little on the mini cheetah ring gears. There I located the rings with a fixture that was a very close fit to the ID for machining. Some of the rings took a litle prying to remove from the fixture after machining most of the OD away, suggesting they ovalized slightly. But in that case, the rings were pressed into a housing that forced them back to round.
Thanks! Your comment has been submitted and will appear after moderation.
Comments